Electrician in Jilliby, NSW
Electrical work in Jilliby, NSW
Jilliby is a large rural locality with farms and bushland, in the Dooralong Valley, north-north-west of Wyong. The Jilliby State Conservation Area is nearby, and Little Jilliby is a separate suburb next to it. Our work is on the property you call about, so the switchboard, the cable runs and any shed or pump on that block are where the job sits. On a visit, we start at the switchboard and the meter box on that property.
On a rural block, access can be the slow part of a visit. Tell us if the driveway is long or unsealed, whether a gate or a grid is locked, and who holds the key or the gate code. Tell us whether the owner or a tenant holds the key. If the switchboard or the pump is in a shed, the shed must be open on the day, and we need room to park a work vehicle near it. If the owner is away, make sure the key holder can be reached during the visit.
Homes on these blocks are detached houses, and each one has its own switchboard, so a job at one home stays on that home's wiring. A home's age is hard to read from the road, so we check the switchboard and the wiring on the day. A home built before safety switches were common can have a fuse box, no safety switches, or old rubber-insulated cable, and that is what we look for first.
What we do here most
Jobs we do in Jilliby
These four jobs cover an outage, a fault at a pump or shed, a second building that needs power, and a car charger. Each one starts at the switchboard, so the visit depends on how far the switchboard is from the road.
24/7 emergency electrical
Storm outage on a long rural driveway
If the power goes off in a storm, check whether the road or the next property still has power. If only your home is dark, the fault may be on the service line from the pole or in the switchboard. Do not walk under a fallen line, and do not touch a wire on the ground or a tree touching a line. We answer the phone at any hour, every day, so call us and tell us what you see.
electrical repairs
A water pump that cuts out at the shed
If the pump sits a long way from the house, the fault can be at the far end of the cable rather than at the pump. We check the circuit back to its safety switch, test the pump's motor and its isolator, and look for water in the box or in the cable joints. Switch the pump's own isolator off before anyone opens its box, and keep the lid shut until we arrive.
full switchboard upgrades
A shed that needs its own sub-board and circuits
If a shed or workshop on the block is fed from the house by a long cable, it may need its own sub-board with safety switches. Before we add circuits, we open the main switchboard, check the main switch, the spare ways and the earthing, and confirm the cable can carry the new load. Tell us what you plan to run in the shed, because a welder needs a different circuit from a light.
electric vehicle charger installation
A car charger on a long cable run
If the car will charge in a shed or at the far end of the house, the cable run is longer and the cable must be sized for it. We check that the switchboard has room for a new circuit before we install, because a charger on a shared circuit can overload it. Tell us where the car will park and where the switchboard is, since the distance changes the cable and the job.
If it is urgent
If the power drops at a Jilliby home after dark
- 1Step 1: Walk to the switchboard and press the test button on each safety switch. A safety switch that trips when you press its test button is working, so switch it back on once. If it trips again straight away, leave it off.
- 2Step 2: Do not walk under or touch an overhead line, a wire on the ground, or a tree that is touching a line. Do not open the meter box, and do not run a generator into a power point, because it can feed back into the supply.
- 3Step 3: When you call, tell us the road name and the property, whether the road or the next property still has power, which safety switch tripped, and whether a gate or grid is locked between the road and the house.
Common questions
Frequently Asked Questions
Do you work out of hours?
Yes. We are open 24 hours a day, every day, and we answer the phone at any hour. Urgent problems such as sparking outlets, burning smells and tripped circuits are part of our emergency electrical work.
Do you come to my home or business?
Yes. We travel to our customers, so we work at your home or business. This site does not list a street address.
Which areas do you cover?
We cover the Central Coast and Newcastle, NSW, and we are based in Kanwal. The list of suburbs on this site shows the places we work in.
What should I do before you arrive if the power is off?
First, check whether the power is off across the street or only at your place. Do not open the switchboard, and do not touch any wiring that is sparking, hot or wet. If you smell burning or see smoke, get everyone out and call emergency services first. When you call us, tell us what you have checked.
Do you give quotes?
Yes. Our process includes a quote. The steps run in this order: a first phone call, the quote, then the day of work and handover.
How much does the work cost?
The cost depends on the job, so this site does not publish figures. To get one, start with a first phone call, which leads to a quote.
How quickly can you get to me?
We do not promise a response time on this site, because it depends on the job and on where you are. We answer the phone at any hour, every day, so call us and describe the problem.
Do you work on rental properties?
Yes. Our test and tagging service covers rental properties. Our strata and real estate electrical maintenance is tailored for property managers, with routine inspections, emergency repairs and compliance checks.
Do you install battery storage?
Yes. Installing battery storage systems is part of our residential electrical work, alongside EV charging stations.
Do you work on older homes and old wiring?
Yes. We remove and replace old or unsafe wiring, including cloth or aluminium wiring. Our full property assessments look for risks, outdated wiring and safety concerns.
Do you work for businesses?
Yes. Our commercial electrical work includes wiring and rewiring for offices, shops, warehouses and communal buildings, along with switchboard upgrades and routine maintenance. We also test and tag plug-in appliances at workplaces.
Do you install EV chargers?
Yes. We install EV chargers for homes and businesses. We assess your property to work out where the charger should go, and the work can include load balancing, surge protection and switchboard upgrades where needed.
What services do you offer?
We do residential and commercial electrical work across the Central Coast and Newcastle. Our service pages list each type of work, including home rewiring, lighting, switchboard upgrades, smoke alarm testing, EV chargers, data cabling, test and tagging, and emergency repairs.
Do you test smoke alarms?
Yes. We test every smoke detector to check that it works and to check its battery life. We also install and replace smoke alarms, including interconnected ones.
Everything we do here
Services in Jilliby, NSW
Each service below is carried out at the property itself, so the list works the same way for a Jilliby home, shed or pump as it does anywhere else we work.
Local, and on the phone
Booking electrical work in Jilliby
The detail that decides how we plan your visit here is how we get to the switchboard from the road. Tell us where the switchboard is and whether a gate or a grid is in the way.
0468 084 63524 hours a day, 7 days a week
Not urgent? Send us the job instead